MIL-PRF-27F

作者:标准资料网 时间:2024-05-11 19:42:41   浏览:8815   来源:标准资料网
下载地址: 点击此处下载

MIL-PRF-27F, PERFORMANCE SPECIFICATION: TRANSFORMERS AND INDUCTORS (AUDIO, POWER, AND HIGH-POWER PULSE), GENERAL SPECIFICATION FOR (25 JUN 1999) [SUPERSEDING MIL-T-27E]., This specification covers the general requirements for power transformers, power inductors, audio transformers, audio inductors, high power pulse transformers, charging inductors, saturable transformers and saturable inductors for use in electronic and communication equipment. This specification covers transformers and inductors weighing 300 pounds or less or having root-mean-square (rms) test-voltage ratings 0f 50,000 volts or less, and also high-power pulse transformers where the peak pulse power is greater than 5 watts. Transformer and inductor assemblies incorporating any other active or passive components do not come within the scope of this specification.

 

MIL-PRF-27F (NOTICE 1), PERFORMANCE SPECIFICATION: TRANSFORMERS AND INDUCTORS (AUDIO, POWER, AND HIGH-POWER PULSE), GENERAL SPECIFICATION FOR (05 DEC 2005)., MIL-PRF-27F, dated 25 February 2001, has been reviewed and determined to be valid for use in acquisition

下载地址: 点击此处下载
基本信息
标准名称:电子玻璃抗冲击强度测试方法
英文名称:Test method for impact resistance of electronic glass
中标分类: 综合 >> 标准化管理与一般规定 >> 技术管理
替代情况:原标准号GB 9622.7-88
发布日期:1996-11-20
实施日期:1997-01-01
首发日期:1900-01-01
作废日期:1900-01-01
出版日期:1900-01-01
页数:1页
适用范围

没有内容

前言

没有内容

目录

没有内容

引用标准

没有内容

所属分类: 综合 标准化管理与一般规定 技术管理
Product Code:SAE J968/1
Title:Diesel Injection Pump Testing-Part 1: Calibrating Nozzle and Holder Assemblies
Issuing Committee:Diesel Fuel Injection Equipment Standards Committee
Scope:This part of SAE J968 specifies two types of calibrating nozzle and holder assemblies intended for the testing and setting of diesel injection pumps on test benches. It applies to: a. A calibrating nozzle and holder assembly with a single hole orifice plate; b. A calibrating nozzle and holder assembly with a delay pintle type nozzle.The approximate range of the calibrating nozzle and holder assembly is up to: a. 300 mm{sup}3/stroke with the single hole orifice plate; b. 150 mm{sup}3/stroke with the delay pintle type nozzle. Setting and maintenance requirements are specified in ISO 4008/3.